The New bFan®
About 2003, we invented the very first Bedfan to become available to the market. It was highly successful and well received. We have been in many magazines, newspapers, television shows etc. The response has been awesome.
From this experience we were able to position ourselves to make the perfect Bedfan, the bFan®.
Over the last 14 years with have talked with many of our customers and listened to their ideas on what they would like to see in the next version of the Bedfan. We took those ideas and have implemented many of them into this new version that we call the bFan®.
These are the things that we have improved on:
The following video will show some of the improvements and how we have accomplished them.
Setting Up The bFan®
The installation of the bFan® is very simple. In this next video we will show you just how simple it is.. For this installation we installed the bFan® at the foot of the bed, which is the preferred location. From the foot of the bed the air will naturally travel along your body and exit at the top of the bed around your shoulders.
The bFan® is intended to deliver the air between the top and bottom sheets of your bed so that it is in direct contact with your body.
One of the nice improvements to this new unit is that the base is extremely sturdy with a wide and deep footing as well as a lower center of gravity. This allows the user to place the fan anywhere they like and not worry about stability. See the following full video for installation instructions.
Installing the new bFan® from the original inventor of the Bedfan
The new bFan® is ready. This is a simple video on how to set it up. https://bedfans-usa.com/products/the-bfanPosted by bFan on Saturday, January 13, 2018
Controlling the bFan®
The bFan® is fully controllable from off to high and all points in between. When you first start using the bFan® you should start with the bFan® on low and gradually work your way up. At the same time you will raise the temperature in your room by a couple degrees each night. The objective is to bring the fan to about half of full power yet still feel cool. After a few nights of doing this you will reach a point of comfort that you have never felt before. This is equilibrium and from this point you can stop changing the thermostat and start sleeping deeper and sounder.
For the first night, set the fan on low and see if it is too cool in bed for you. If your bed is too cool, you need to raise the temperature in your room for the next night. Follow this pattern until you have reached about half power on the fan and you are no longer too cool.
The point of equilibrium is the point at which the bFan® is evacuating your body heat at about the same rate that it is being created. Above equilibrium will be too cool and below equilibrium will be too warm.
By adjusting the thermostat in your house a few degrees at a time, along with adjusting the bFan® speed, you will eventually find that you are significantly reducing the amount of electricity being consumed thus lowering your electric bill at the same time.
The bFan® is not sold on Amazon, click the image for an explanation.
Copyright 2005 - present - Tompkins Research, Inc. & Kurt W. Tompkins All Rights Reserved DO NOT COPY.
bFan® and the word bfan® in any format is a registered trademark of Kurt W. Tompkins the word BFAN® in any format shall not be used without written permission of the mark owner. This includes specifically Brookstone where you like to bait and switch, do not use my mark to bait customers.